DaVinci MIQRO Zirconia 10mm Adapter

Additional information about DaVinci MIQRO Zirconia 10mm Adapter

Table of Contents

• You Should Buy the MIQRO Zirconia 10mm Adapter If…
• How to Attach the Adapter
• Two Uses in One Piece
• Why This One's Zirconia, Not Silicone
• Compatibility

You Should Buy the MIQRO Zirconia 10mm Adapter If…

You should buy the MIQRO Zirconia 10mm Adapter if you want a cooler, water-filtered draw off your MIQRO. It's also useful for when you want a longer, flavor-neutral mouthpiece to swap in for a different feel, even without a water tool attached.

How to Attach the Adapter

The adapter seats into the same top cap opening as the flat mouthpiece, so there's nothing extra to install on the device itself.

Here is the step by step guide:

• Step 1: Power off the MIQRO and open the top cap to remove the flat mouthpiece.
• Step 2: Press the Zirconia 10mm Adapter into the same opening until it sits flush.
• Step 3: Close the top cap, then either draw directly from the adapter or insert its 10mm end into your water bubbler’s female joint.
• Step 4: Power the MIQRO on and run your session as usual.

Two Uses in One Piece

Most water tool adapters are built to seat in a joint and aren't meant for regular direct use, but this one is sturdy enough to work as a standalone extended mouthpiece with no water tool attached at all. That makes it worth keeping around even if you don't own a water piece, since a longer, cooler draw off the zirconia piece is a genuinely different experience from the stock flat mouthpiece. When you do want water filtration, the same piece plugs straight into any 10mm female joint.

Why This One's Zirconia, Not Silicone

The original MIQRO's water and extended mouthpiece option is this zirconia ceramic piece, while the MIQRO-C moved to a separate silicone version for the same job. Zirconia doesn't pick up flavor from past sessions or soften with heat the way silicone can over time.

Compatibility

• Davinci MIQRO